ProtectGuard Wet Finish Special Concrete

Application
  • Impregnating agent with colour enhancing effect
  • Developed for fibre-reinforced and UHPC concrete
  • CALCULATE THE AMOUNT YOU WILL NEED:

     164,00 excl. VAT

    Buy [nextvalue] and save 15% per L
    Make a choice:
    technical information:

    Article code:

    Water and oil repellent stain stopper for fibre-reinforced ultra-high strength concrete (wUHSB)

    Total protection of all types of concrete.
    ProtectGuard® WF Special Concrete is a product for the water and oil repellent treatment of concrete and ultra-high strength concrete. It protects against the penetration of water, oil and all kinds of stains. It facilitates the maintenance of concrete and prevents the main causes of aging such as grease stains, infiltration ...

    ProtectGuard® WF Special Concrete creates a colour enhancing 'wet look' effect, making the colour of the surface darker and more intense.

    ProtectGuard® WF Special Concrete is an ecological product, completely in aqueous phase (non-toxic, without petroleum solvents).

    ProtectGuard® WF Special Concrete is an impregnation product, which keeps the surface permeable to air and water vapour. In addition, it is highly abrasion, scratch and UV resistant and does not yellow over time.

    ADVANTAGES

    • Protection against water, oil and stains. Non film forming, allows the surface to breathe. Colourless
    • Available in matt or glossy
    • Wear-resistant
    • UV- and frost-resistant
    • Delays ageing and easy maintenance

    USAGE

    • All types of concrete: regular concrete, reinforced concrete, fibre-reinforced concrete (wUHSB), strong, alkali-resistant AR glass fibre (GRC)
    • Floors and facades
    • New or old |Inside and outside

     

    Preparation of the substrate:

     

    • Apply the product to a clean, dust- and grease free and dry surface. Use Guard Remover® Eco Efflorescence & Cement to remove grease stains and traces of efflorescence, cement sludge or cement residue.

     

    Application:

     

    • Use the product in its pure form: do not dilute.
    • Shake the container well before use for 5 minutes to homogenise the matting. Carry out a test beforehand.
    • ProtectGuard® WF Special Concrete is applied in 2 layers.
    • Apply a first layer of the product on the entire surface. Allow the product to penetrate and dry (15 to 30 minutes depending on the porosity and temperature of the material) and then apply a second coat.
    • Always ensure perfect treatment by wetting the treated surface with water after drying to check that it is properly protected.
    • Do not overload the surface, quickly eliminate excess product.
    • Leave to dry for 24 hours before reuse.
    • Optimal efficiency can be obtained after 5 to 7 days.

     

    Weight N/A
    Dimensions N/A
    Packaging

    5L